How to measure? Hexagonal model

Tape measure icon How to measure correctly? (Hexagonal / multi-sided model)

A: Measuring on the opening frame (inside)?
➜ Measure the maximum width and the maximum height of the opening (from one extreme point to the other).
➜ Then add +2 cm in width and +2 cm in height (hook-and-loop tape 2 cm all around).

B: Measuring on the final fitting frame (outside / inside)?
➜ Add nothing if you are already measuring the exact surface where the hook-and-loop tape will be stuck (the “final” frame).
➜ In that case, simply measure the max width + max height.

Information icon Specific to the hexagonal model: 2 measurements are enough

For the hexagonal / multi-sided, we only need:

  • Maximum width : from the leftmost point to the rightmost point.
  • Maximum height : from the lowest point to the highest point.

➜ Important: the hook-and-loop tape is 2 cm all around. If you measure the inside of the opening, make sure to add +2 cm in width and +2 cm in height to obtain the final size.

Measuring diagram for hexagonal fly screen (max width, max height)
Information icon

Need an adjustment?
➜ The fly screen can be folded back slightly if needed, without affecting use.

Tip icon

Tip: always round up to the nearest centimetre
➜ Better a bit too big than too tight 😉